POLIFORMA 2110 polyurethane injection foam: when renovating a house is easy

Spain's housing stock has one of the highest energy costs in the country. This is due to the fact that most of the old dwellings were built before the Technical Building Code (CTE), in which importance was given to the insulation of dwellings and their energy efficiency. In these dwellings there is no insulation per se, but only cavity walls.

Insulate without knocking down walls

Insulation in new buildings is quite easy, as all you have to do is to design the foam from polyurethane But what can be done when the house is already built and inhabited? Can owners of old buildings improve energy efficiency by air conditioning? The answer is Yes, with our foam injection P2110.

Tearing down the interior partition walls of houses to install insulation is not a good solution, as it increases the cost of the renovation in addition to the inconvenience and time it would take to carry out the complete work.

For these cases Formulaciones has in its wide range of manufactured products the foam from polyurethane injected POLIFORMA 2110. This foam is injected into the air gap between the exterior walls of the house and the interior. With this solution, no major building work is required, just a series of holes in the wall where the air is injected. foamThe building is completely isolated in a short time and with little disturbance to its inhabitants. Moreover, depending on the conditions of the renovation, it can even be done from the outside wall, so that the inconvenience to the occupants of the house would be minimal.

We recommend you to visit our website ▶▶▶. https://formulaciones.es/  Here you can consult the rest of our product families, designed to adapt to any of your needs, features and budgets.